Anton_bauer DUAL 2722 Manuel d'utilisateur télécharger pdf (Page 7)

LED Indications

The DUAL 2722 has two sets of two LEDs (one red, one green) and one green status

LED in the center. The green status LED indicates: Steady green – line voltage is

present; Off – line voltage not present.

The red and green charge status LED’s indicate the charging status of the battery. The

following table identifies all of the LED indications and their meaning. Please note that

the right side charge position will not illuminate the red or green LEDs when power is

being drawn from the 4 pin XLR, unless a battery is present.

LED INDICATION MEANING

Alternating

Red & Green

Indicates that the DUAL 2722 is evaluating the battery and/or

communicating with a DIGITAL battery, loading battery

parameters and determining the appropriate charge routine. A

low voltage (<11V) battery will cause this indication to

continue until the battery reaches safe charging voltage.

Steady Red Indicates that the battery is being held by the DUAL 2722 to

stabilize an out-of-range temperature condition, or camera supply

is in use (right side only).

Or it can also indicate if a non-Anton/Bauer Logic Series battery

has been mounted on the charger. These batteries cannot identify

themselves to the DUAL 2722 and will not be charged.

Flashing Red Indicates that the battery is currently under Stage One charge.

Flashing Green

(slow rate)

Indicates that the battery is currently under Stage Two charge.

Flashing Green

(fast rate)

Indicates a fully charged DIGITAL battery is placed on the

charger and a FUL cutoff condition cannot be met. The charger

is VERIFYING that the battery is in a full charge condition.

Steady Green Indicates that the battery is READY and in Stage Three Lifesaver

mode.

Green Status LED

Red/Green Charge Status LED

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Pas de commentaire

Anton_bauer DUAL 2722 Manuel d'utilisateur Page 7